NRP 10-DPS (TRAY)
Part No.: MPHS-NRP-10-DPS (TRAY)
PROFIBUS DP Slave: Ready-to-solder netX Design in stamp size
產品介紹
Features
- Complete Slave interface with smallest footprint
- Significant space savings due to integrated transformers
- Host connection via Dual-Port Memory or SPI
- One circuit board design for all Fieldbusses
Product Description
The network technology in automation devices from medium to high volumes is typically integrated with a chip solution, such as the flexible multiprotocol chip netX. The complete development of the communication interface is thereby carried out by the customer from scratch. Low costs per unit are opposed to development risk, increased development time and necessary in-house knowledge.
The rapid and secure alternative to in-house development is netRAPID.
netX Chip-Carrier is a solution that offers adequate costs per unit as well as reduced risk and fast time-to-market. netRAPID is a complete netX-based communication interface and contains all necessary operating components. The 32 x 32 mm compact netX carrier will be soldered to the baseboard - by hand or SMD production process. You only need to add network interface, LEDs and address switches. A simple 2-layer baseboard is sufficient.
Full functionality of netRAPID is enabled via licensed firmware, which needs to be acquired once and loaded during manufacturing process.
Technical Details
| Product | Product Name | NRP 10 |
|---|---|---|
| Part Number | 7650.420 | |
| Brief Description | Chip carrier with PROFIBUS DP Slave interface | |
| Communication Controller | netX: netX 10 | |
| Integrated Memory |
RAM: 4 MB serial Flash EPROM |
|
|
Power Supply and Current |
Supply voltage: +3,3 V DC ± 5 % Maximum current (typically): 290 mA/790 mA (at 3,3 V) Power consumption (typical): 1 W |
|
|
Host Interface |
Type: Parallel dual-port memory or serial dual-port memory (SPI, mode 3)
Connector: 76-pin solder contacts 1 mm with 1.5 mm grid Dual-port memory size: 16KB (14 address lines), where 8 KB used by firmware (13 address lines, lowest 8 KB) Width for the data access to the dual-port memory (DPM): 8 or 16 bit Baud rate (serial dual- port memory): Max. 50 MHz |
|
|
Communication Interface |
Communication standard: PROFIBUS DP Slave Interface type: RS-485, isolated |
|
|
Diagnostic Interface |
Type: USB or UART Connector: USB or UART: Signals at Chip Carrier, available only if integrated in host system |
|
| Display |
LED displays:
|
|
|
Operation Elements |
Network address: 2 rotary switches for address
|
|
| Environment | Ambient temperature range for operation: -20 °C … +70 °C (at an airflow of 0,5 m/s) | |
| Device |
Dimensions (L x W x H): 32 mm x 32 mm x 4 mm Weight: approx. 3 g Electrostatic discharge (ESD) according to IEC/EN 61000-4-2:1995 (Contact discharge method): 6 kV Criterion A Fast transient interferences (Burst), according to IEC/EN 61000-4-4:1995 (Communication and data lines): 2.2 kV Criterion B Surge voltage, according to IEC/EN 61000-4-5:1995 (Communication and data lines): 1 kV Criterion A |
|
Ordering Information
- NRP 10-DPS (TRAY) (7652.420) - netx Chip carrier - PROFIBUS DP Slave