products

NRP 10-CCS (TRAY)

Part No.: MPHS-NRP-10-CCS(TRAY)
CC-Link Slave: Ready-to-solder netX Design in stamp size

產品介紹

Features

  • Complete Slave interface with smallest footprint
  • Significant space savings due to integrated transformers
  • Host connection via Dual-Port Memory or SPI
  • One circuit board design for all Fieldbusses

Product Description

The network technology in automation devices from medium to high volumes is typically integrated with a chip solution, such as the flexible multiprotocol chip netX. The complete development of the communication interface is thereby carried out by the customer from scratch. Low costs per unit are opposed to development risk, increased development time and necessary in-house knowledge.

The rapid and secure alternative to in-house development is netRAPID.

netX Chip-Carrier is a solution that offers adequate costs per unit as well as reduced risk and fast time-to-market. netRAPID is a complete netX-based communication interface and contains all necessary operating components. The 32 x 32 mm compact netX carrier will be soldered to the baseboard - by hand or SMD production process. You only need to add network interface, LEDs and address switches. A simple 2-layer baseboard is sufficient.

Full functionality of netRAPID is enabled via licensed firmware, which needs to be acquired once and loaded during manufacturing process.


Technical Details



Product Product Name
Part Number
Brief Description
Netwrok
Controller		 netX: netX 10
Integrated
Memory		 RAM: 4 MB serial Flash EPROM
Power
Supply and
Current		 Supply voltage: +3,3 V DC ± 5 %
Maximum current (typically): 360 mA/710 mA (at 3,3 V)
Power consumption (typical): 1.2 W
Host
Interface		 Type: Parallel dual-port memory or serial dual-port memory (SPI, mode 3)
Connector: 76-pin solder contacts 1 mm with 1.5 mm grid
Dual-port memory size: 16 KB (14 address lines), where 8 KB used by firmware (13 address lines, lowest 8 KB)
Width for the data access to the dual-port memory (DPM): 8 or 16 bit
Baud rate (serial dual-port memory): Max. 50 MHz
Communication
Interface		 Communication standard: CC-Link Slave
Interface type: RS-485, optically isolated
Diagnostic
Interface		 Type: USB or UART
Connector: USB or UART: Signals at Chip Carrier, available only if integrated in host system
Display LED displays:
  • SYS System status
  • L RUN/L ERR Communication status
Permitted
Ambient
Conditions		 Ambient temperature range for operation: 0 … +70 °C (at an airflow of 0.5 m/s)
Device Dimension (L x W x H): 32 mm x 32 mm x4 mm
Weight: approx. 4 g

 

Ordering Information

  • NRP 10-CCS (TRAY) (7652.740) - netX Chip carrier - CC-Link Slave
返回列表