products

PCAN-AU5790

Part No.: MPPK-IPEH-002040
The PCAN-AU5790 bus converter establishes a connection between a High-speed CAN bus (ISO 11898-2) and a Single-wire CAN bus (SAE J2411).

※ Microport is the exclusive authorized distributor of PEAK-System in Taiwan.

Product Description

Description

The PCAN-AU5790 bus converter establishes a connection between a High-speed CAN bus (ISO 11898-2) and a Single-wire CAN bus (SAE J2411). One of the most important potential applications of the bus converter is a simple connection between a PEAK CAN interface (e.g. PCAN-USB) and a Single-wire CAN bus.
 

Specifications

  • There are three different operating modes for the SW-CAN side which can be set using a sliding switch. Normal (33.3 kbit/s), High-speed (83.3 kbit/s) and Wake-up
  • Indicator LEDs for power supply (red) and wake-up signals (yellow)
  • 5-Volt power supply (150 mA) through HS-CAN connection (a current list of PEAK CAN interfaces with suitable supply voltage is available on request)
  • If the power supply has a current output lower than 150 mA, an additional 12-Volt supply is needed via the SW-CAN connector
  • Operating temperature range from 0 to 70 °C (32 to 158 °F)

Pin Assignment Female D-Sub Connector

1　5V Power supply
2　CAN-L
3　GND
6　GND
7　CAN-H
9　Not connected / optional +5V
 

Pin assignment Male D-Sub Connector


3　GND
5　CAN
6　GND
9　VBAT

Scope of Supply

  • IPEH-002040: Adapter in plastic casing
  • Manual in PDF fornat

Note:

1. Prices and specifications are subject to change without notice.
2. EOL products will not be notified separately.
3. Product images are for reference only. Actual products may vary depending on the version or specifications.
4. Product information, specifications, and availability are subject to confirmation at the time of order.
Back