|
Device |
|
Maximum Input Protection Voltage (Channel) |
±100 V (indefinitely), ±200 V (short-time, t < 2 ms) |
|
Channel Sampling Rates |
1/ 2/ 5/ 10/ 20/ 50/ 100/ 200/ 500 Hz |
|
Channel Sampling Rates |
1/ 2/ 5/ 10 kHz (CAN up to 2 kHz) |
|
Aggregate Sample Rate |
80 kHz |
|
Oversampling |
10 kHz |
|
Voltage Supply |
9 … 36 VDC |
|
Supply Voltage Thresholds |
Switch-on 9 ±0.3 VDC / Switch-off 6 ±0.3 VDC |
|
Power Consumption, Typical |
4.0 W (all excitations off) |
|
Working Temperature Range |
-40 … 85 °C (-40 … 185 °F) |
|
Storage Temperature Range |
-55 … 105 °C (-67 … 221 °F) |
|
IP-Code |
IP 67 (ISO 20653 - 2013) |
|
Relative Humidity |
5 ... 95 % |
|
Dimensions |
W212 mm x H41 mm x D55 mm (8.35 in x 1.61 in x 2.17 in) |
|
Weight |
690 g (1.52 lb) |
|
Configuration Interface |
Ethernet |
|
Data Transfer Rate |
100 Mbit Ethernet (IEEE 802.3) |
|
Input Sockets |
Lemo EGG 1B 307 (7-pin) SIM-DMS compatible |
|
Galvanic Isolation |
|
Input ↔ Module Power Supply |
±100 V (indefinitely), ±200 V (short-time, t < 2 ms) |
|
Input ↔ CAN |
±100 V (indefinitely), ±200 V (short-time, t < 2 ms) |
|
Input ↔ Enclosure |
±100 V (indefinitely), ±200 V (short-time, t < 2 ms) |
|
Input ↔ Input |
±100 V (indefinitely), ±200 V (short-time, t < 2 ms) |
|
Input ↔ Excitation |
±100 V (indefinitely), ±200 V (short-time, t < 2 ms) |
|
General Channel Properties |
|
A/D Converter |
16 bit / SAR (successive approximation register) |
|
Special Functions |
Offset adjust, during measurement, multiple groups |
|
Sensor Break Detection |
For sensor excitation |
|
Channel LED |
Available |
|
Flashing Mode of Channel LED |
During configuration - blinking |
|
Channel Impedance |
10 MΩ |
|
TEDS |
Class 2 |
|
Hardware Filter (Fixed) |
5 kHz cut off fequency |
|
Hardware Filter (Fixed) |
Type RC 4-pole |
|
Hardware Filter (Fixed) |
Accuracy 25 % |
|
Hardware Filter (Switchable) |
Type Butterworth (8-pole) |
|
Hardware Filter (Switchable) |
1.2 kHz cut off frequency |
|
Hardware Filter (Switchable) |
Accuracy 10 % |
|
Software Filter Types |
Butterworth, Bessel, Elliptic (8-pole) |
|
Software Filter (DSP Selectable) |
1/ 1.25/ 1.67/ 2.5/ 5/ 6.67/ 10/ 12.5/ 16.67/ 25/ 50/ 66.67 Hz |
|
Software Filter (DSP Selectable) |
100/ 125/ 166.67/ 250/ 500/ 667.67 Hz |
|
Software Filter (DSP Selectable) |
1.0/ 1.25/ 1.67/ 2.5/ 3.34 kHz |
|
Software Filter (DSP Selectable) |
Accuracy 0.05 % |
|
Channel Current |
|
Measurement Range Current |
0 … 20 mA, ±20 mA |
|
Accuracy at Ambient Temperature 25 °C |
±0.40 % |
|
Internal Shunt Resistor |
50 Ω |
|
Excitation |
|
Sensor Excitation Ranges |
Bipolar ±2.5/ ±5/ ±7.5/ ±8/ ±10/ ±12.5/ ±15V |
|
Accuracy Excitation at Ambient Temperature 25 °C |
±0.25 % |
|
Accuracy Excitation at Ambient Temperature 85 °C |
±0.40 % |
|
Sensor Excitation Current |
30 mA (for V output ±2.5 / ±10.0 V) |
|
Sensor Excitation Current |
40 mA (for V output ±5.0 / ±12.5 V) |
|
Sensor Excitation Current |
45 mA (for V output ±7.5 / ±15.0 V) |
|
Channel Volt |
|
Measurement Range SENS |
±0.01/ 0.1/ 0.2/ 0.5/ 1/ 2/ 5/ 10/ 20/ 30/ 50/ 100 V |
|
Accuracy at Ambient Temperature 25 °C |
±0.10 % (unipolar measurement ranges) |
|
Accuracy at Ambient Temperature 25 °C |
±0.06 % (bipolar measurement ranges) |
|
Drift for Ambient Temperature -40 … 85 °C |
40 ppm/K |
|
Accessories |
|
System Cable |
630-302.pdf |
|
System Cable |
630-524.pdf |
|
System Cable |
630-507.pdf |
|
System Cable |
630-501.pdf |
|
System Cable |
630-522.pdf |
|
System Cable |
630-500.pdf |
|
System Cable |
630-504.pdf |
|
System Cable |
USB2ETH-XLINK.pdf |
|
System Cable |
X-Link-DEF.pdf |
|
System Cable |
X-Link-TERM.pdf |
|
System Cable |
600-866.pdf |
|
Input Cable |
620-674.pdf |
|
Input Cable |
670-807.pdf |
|
Input Cable |
670-810.pdf |
|
Input Cable |
670-811.pdf |
|
Input Cable |
SENS8-TEDS.pdf |
