Part No.: MP-IPET-M-THERMO2
8-channel thermocouple measurement inputs type K (NiCr/NiAl)
Device | |||
Maximum Input Pprotection Voltage (Channel) | ±50 V (indefinitely), ±200 V (short-time, t < 2 ms) | ||
Channel Sampling Rates | 1/ 2/ 5/ 10/ min -- 1/ 2/ 5/ 10/ 20/ 50/ 100 Hz | ||
Aggregate Sample Rate | 800 Hz | ||
Voltage Supply | 6 … 36 VDC | ||
Supply Voltage Thresholds | Switch-on 6 ±0.3 VDC / Switch-off 6 ±0.3 VDC | ||
Power Consumption, Typical | 1.1 W | ||
Working Temperature Range | -40 … 125 °C (-40 … 257 °F) | ||
Storage Temperature Range
|
-55 … 150 °C (-67 … 302 °F) | ||
IP-Code | IP 67 (ISO 20653 - 2013) | ||
Relative Hhumidity | 5 … 95 % | ||
Dimensions | W106 mm x H30 mm x D57 mm (4.17 in x 1.18 in x 2.26 in) | ||
Weight | 315 g (0.69 lb) | ||
Configuration Interface | CAN high speed | ||
Data Transfer Rate | Software selectable up to 1 Mbit/s (ISO11898-2) | ||
Test Standards | IEC 61010-2-201 | ||
Input Sockets | Miniature TC connector green (DIN IEC 584) | ||
Input Sockets | Miniature TC connector yellow (ANSI MC 96.1) | ||
Galvanic Isolation | |||
Input ↔ Module Power Supply | ±100 V (indefinitely), ±500 V (pulse voltage) | ||
Input ↔ CAN | ±100 V (indefinitely), ±500 V (pulse voltage) | ||
Input ↔ Enclosure | ±100 V (indefinitely), ±500 V (pulse voltage) | ||
Input ↔ Input | ±100 V (indefinitely), ±500 V (pulse voltage) | ||
General Channel Properties | |||
A/D Converter | 24 bit (Sigma/Delta) | ||
Sensor Break Detection | Activation via software settings | ||
Channel LED | Available | ||
Flashing Mode of Channel LED | During configuration - blinking | ||
Flashing Mode of Channel LED | Break detection | ||
Channel Impedance | 4.0 MΩ | ||
Hardware Filter (Fixed) | 10 Hz, filter type RC-low-pass | ||
Channel Temperature | |||
Measurement Range Temperature | Type K (NiCr/NiAl) -60 … 1370 °C (-76 … 2498 °F) | ||
Accuracy at Ambient Temperature 25 °C | ±0,035 % for full measurement range | ||
Accuracy at Ambient Temperature 25 °C | ±0,025 % typical | ||
Drift for Ambient Temperature -40 … 125 °C | ±40 ppm/K | ||
Drift for Ambient Temperature -40 … 125 °C | ±10 ppm/K (from hardware release 3.30) | ||
Linearization of Sensor Characteristic Line | Numerical interpolated | ||
Cold Junction Compensation (CJC) | PT100 for each input | ||
Accessories | |||
System Cable | 620-561.pdf | ||
System Cable | 620-502.pdf | ||
System Cable | 620-560.pdf | ||
System Cable | M-CAN-ABS.pdf | ||
System Cable | M-DEF-200.pdf |