|
ATA PC-Card Adapter
Part No:MPMPL-PCs-IDE2PCC
The IDE2PCC is a cost effective and easy to use
adapter for connecting PCMCIA PC Cards ATA with true IDE interface (PC
Cards) to the standard IDE port of a single board computer (SBC) from
MPL or other manufacturers. The IDE2PCC adapter has up to two PC Card
Standard slots for type I, II or III cards. Allowing the use of any 5 V
PC Card ATA or PCMCIA ATA card.
For mechanical fixing in MPL’s PIP family, the
IDE2PCC can be connected to the PC/104 slot. The PC Card slot is then
available on the right side of the PIP case. For mounting on top of
other SBCs, the mounting holes defined in the PC/104 specification are
available.
The IDE signals are connected to the IDE2PCC via
a standard 40 or 44 pin IDE cable. The power is distributed either with
the 44 pin IDE cable or through the PC/104 connector.
With IDE2PCC the storage cards are used like IDE
hard disks, they are not hot plug capable in IDE2PCC. If you require hot
plugging support, use the
PCCARD
Module of MPL AG.
IDE2PCC Specialities
- Bootable storage interfaces
- Master/Slave selection
- Easy to use & inexpensive
- PC/104 form factor
- Up to two PC Card Standard slots dual type
I/II or single type III card
- Optional separate power connector
- 44 pin (optional 40 pin) IDE connector
These features make the IDE2PCC adapters
to an inexpensive, ideal solution if you need an easy exchangeable
storage media. The adapters allow booting from this device and give your
system more flexibility. Furthermore the PC/104 form factor relieves the
mechanical installation into your system.
Technical Features
|
PC Card Interface |
| Card Types supported |
Only PCMCIA PC Cards with a
true IDE interface |
Use the
PCCARD Module for other
card types! |
| Interface Voltage |
5V only |
via 44-pin IDE connector or through PC/104
connector |
|
Physical/Power |
| Power |
+5VDC +/-5% |
|
| Temperature Range |
-20°C up to 70°C |
|
| Humidity |
5% - 95% non condensing |
|
|
Operating Systems |
| All Operating Systems that
support IDE media will work with the IDE2PCC. However, please note
that Hot-Plug support for standard IDE media is not supported by
most operating systems. |
IDE2PCC Versions
| IDE2PCC-[Slots][PC/104
Connector][IDE Connector] |
| Slots: |
| 1 |
Single PC Card Slot |
| 2 |
Dual PC Card Slot |
| PC/104 Connector: |
| A |
PC/104 stack-through connector
assembled |
| N |
No PC/104 stack-through connector |
| IDE Connector: |
| 40 |
40-pin, 2.54 mm pitch IDE connector
assembled |
| 44 |
44-pin, 2 mm pitch IDE connector
assembled |
|
Example: IDE2PCC-1N40
- Single Slot
- No PC/104 connector
- 40-pin IDE connector
|
|
